Idézet: Etele - Dátum: 2004. dec. 2., csütörtök - 18:08
Én SMART-nál csak azt nézem, hogy "rendben"-t ír-e az értékek mellé.

Az nem biztos, hogy mindig megfelelő eljárás

:
01 Raw Read Error Rate 20 100 253 0 OK: Value is normal
03 Spin Up Time 20 80 80 2542 OK: Value is normal
04 Start/Stop Count 8 99 99 805 OK: Value is normal
05 Reallocated Sector Count 20 99 99 7 OK: Value is normal
07 Seek Error Rate 23 100 100 0 OK: Value is normal
09 Power-On Time Count 1 98 98 1556 OK: Value is normal
0A Spin Retry Count 0 100 100 0 OK: Always passing
0B Calibration Retry Count 20 100 100 0 OK: Value is normal
0C Power Cycle Count 8 99 99 800 OK: Value is normal
0D Soft Read Error Rate 23 100 93 0 OK: Value is normal
C2 Temperature 42 79 71 81 OK: Value is normal
C3 Hardware ECC Recovered 0 100 100 121319 OK: Always passing
C4 Reallocation Event Count 20 100 100 0 OK: Value is normal
C5 Current Pending Sector Count 20 100 100 3 OK: Value is normal
C6 Off-Line Uncorrectable Sector Count 0 100 253 0 OK: Always passing
C7 Ultra ATA CRC Error Rate 0 200 200 0 OK: Always passing